Beyond Petroleum Equipment

31

2023

-

03

Beyond XJ150 Workover Rig

Author:


Recently Beyond signed a contract with our client from Albania for a XJ150 workover rig.

Beyond XJ150 Workover Rig

 

Recently Beyond signed a contract with our client from Albania for a XJ150 workover rig.

The workover rig is truck-mounted drilling equipment,which is based on  HOWO truck 2 axles chassis. It is mainly consists of sub-frame, PTO, hydraulic torque converter, drawworks and its brake system, angle gearbox, duplex telescoping mast, travelling system, weight-indicator, air system and electrical system .

The maximum hook load is 360k N, the mast height is 18m, and the workover depth is 1600m  (73mmEUE) .

The power system: the vehicle is powered by WD615.87 engine, and then the power transfer to drawworks through PTO of full power, hydraulic torque converter, transmission shaft and angle gearbox. The drawworks drive the crown block and hook with wire rope to realize oil pipe up and down.

Mast assembly: Double telescopic mast, hoisting and telescoping with hydraulic cylinder; the angle is 5.5°and adjusted with adjusting screw; the crown block is who le-box type structure with guardrail.

Drawworks assembly: single-drum structure, the maximum fastline pull is 100k N, band brake.

Hydraulic and pneumatic control system: hydraulic system is used for adjusting jack, lifting oil cylinder, telescoping oil cylinder, support cylinder and hydraulic tong; pneumatic system is used for controlling drawworks clutch, emergency brake cylinder and engine throttle.

 

 

 

XJ150 Workover Rig,Workover Rig